how I resolved certain camera issues. User assumes all
responsibility and risk
Problem: After the Mod All Functions possible but
camera will not shutter a picture.
Verification: Turn AF luminator
on, Press shutter half-way, Verify AF luminator turns on.
Possible Cause: Solder bridge occurred during the modification.
Solder blob causing a short on the switch.
Possible Solution: Use some Desoldering Braid
to remove excess solder. This Desoldering braid can be found at
Radio Shack #64-2090. Lay Braid on solder blob, apply solder iron
momentarily to braid. Check switch for solder blob removal status.
Repeat until solder blob is removed. Take caution not to over heat
and damage the switch.